When engineers working on the Orion capsule needed to attach wire harnesses, fluid lines and control systems, drilling into the capsule was not an option for those attachments. They needed a way to position components while preserving the integrity of the structure.
That is the kind of problem that makes fastening worth discussing early in a design. How a component gets attached can influence where it goes, what the surrounding structure requires and how much work the installation will take.
I recently joined Eric White on his show, The Space Hour, on the Federal News Network to talk about adhesive bonding in aerospace. The conversation covered applications from spacecraft to electric aircraft, but the practical question running through it was one I hear all the time: how do you give engineers more freedom while meeting the requirements of the vehicle?
The Space Hour | Federal News Network
Getting down to the nuts and bolts of what it takes to keep space craft together (minus the nuts and bolts part)
Available on
Start with the requirements
At Click Bond, our work begins with understanding the application. What loads will the attachment experience? What temperatures, chemicals or other environmental conditions will it face? How will it be installed and maintained?
The hardware and adhesive have to be considered together. We work with the customer’s design team to develop a test plan, establish baselines and evaluate performance against the requirements of the intended structure. Static and dynamic testing help us understand how a bonded attachment behaves and how it can fail.
That process gives the engineering team evidence it can use to make a design decision. It also makes clear why there is no single adhesive solution for every application.
Installation deserves the same attention
One example I shared involved Vertical Aerospace in the UK. The aircraft required a little over 9,500 bonded components. The installation process used Mylar templates to map their locations.
By working together on digital solutions, including augmented reality to locate the parts, we helped reduce a process that normally took three months to five days. That result came from looking at the installation workflow as well as the attachment itself.
For manufacturers, the method used to locate and install thousands of parts can become a substantial part of the production challenge. Bringing that question into the engineering conversation creates room to improve the process.
Use bonding where it makes sense
Bonding will never replace every bolt, rivet or screw. Mechanical fastening remains the right solution in a lot of situations. The opportunity here is to understand where a bonded attachment can meet the requirement and offer an advantage.
On one program, installing 25,000 nut plates using the traditional method would have required 75,000 holes. Moving to bonded nut plates eliminated 50,000 of those holes. That is a clear example of how an attachment choice can change the work required on a structure, and it creates real efficiencies for the teams we work with.
Moving to bonded nut plates eliminated 50,000 of those holes.
The right answer for you depends on the application. I know that engineers need confidence in the performance, a workable installation process and a clear understanding of the trade-offs. Those questions are easier to address when fastening is part of the conversation from the beginning.
Go deeper
The Benefits of Bonding
Improved cycle time, reduced FOD, decreased weight, better structural integrity, and lower cost. See how adhesive-bonded fasteners deliver all these benefits and more.
Benefits of Bonding →Every hole is a decision
The Orion team didn't start with a fastener. They started with a constraint: no holes. That constraint pushed them to a better answer.
Most programs don't have a rule that strict. But every hole is still a decision, with a cost in labor, schedule and structure. It's worth treating it like one. Ask early whether the hole needs to be there at all. Test the alternative. Look at what installation will really take.
If your team is working through an attachment challenge on a new vehicle or production line, I'd like to hear what you're running into.
Listen to my full conversation with Eric on The Space Hour.
